Glueing gunwales and stringers

During the past three days I glued gunwales and stringers to the hulls. The gunwales required a lot of bending so that they would fit to the side panels. This meant that they needed to be screwed to ply so that they would keep their bent form. I started by placing the screws to correct places so that the screws just need to be tighten:

Preparing screws

After the screws were prepared I just applied the epox and then bent the gunwale to shape and tightened the screws. The gunwale is bent quite much where rear deck is connected to the main deck.
Gunwale glued

The stringers were glued in similar manner as the gunwales (they were only easier because they didn’t need to be bent).

Leave a Reply

*
To prove you're a person (not a spam script), type the answer to the math equation shown in the picture. Click on the picture to hear an audio file of the equation.
Click to hear an audio file of the anti-spam equation

Why ask?